TREVIDEA g3ferrari STIROPIU' Manual Del Usuario página 14

After use, store power cord and steam tube in their wire
storages.
When inside the boiler there is a pressure such as to
produce steam, do not screw the cap off. Only when the
pressure decreases, the cap can be opened.
Do not use the ironing system as a heating unit.
Always unplug the appliance before you fill or empty the
tank.
We recommend the use of demineralized water to avoid
excessive fouling (not covered by warranty).
Do not fill the tank above the maximum capacity and do
not introduce into the tank mixtures for removing stain,
vinegar, descaling agents or chemicals in general.
Use the appropriate refill cup to fill the tank of the boiler;
do not fill it directly under the tap or with very cold
liquids. Always select the most suitable temperature
according to the fabric to be ironed.
After ironing, drain all the water pushing the appropriate
release button, empty the tank and wait for the cooling of
all parts before storing the system.
The iron must be used and rested on a stable surface. Do
not pull the cord to unplug the unit.
The iron should not be used if it has been dropped, if
there are visible signs of damage or if it leaks.
If the internal pump makes a long and strong noise, check
if there is water in the container, and fill it immediately to
avoid pump damaging.
CAUTION: the iron plate gets very hot during use,
be careful not to touch it, serious risk of burns. Do
not put your face near the steam coming out the iron
plate.
NEVER REMOVE the plastic cap (L) if the unit is still
hot or when it has been used recently.
CAUTION: rinse the boiler once a month, or every 10
uses, to avoid damages due to limestone. In this way,
13