Tabla De Contenido - Sauder 410367 Manual Del Usuario

Table of Contents
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Part Identifi cation
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A3 UPPER RIGHT END (1)
B3 UPPER LEFT END (1)
C2 LOWER RIGHT END (1)
D2 LOWER LEFT END (1)
E3 TOP (1)
F BOTTOM (1)
Page 2
Assembly Tools Required
2-3
4
5-19
20-23
24-27
28-30
31
G3 SHELF (1)
H3 LARGE BACK (1)
I2 SMALL BACK (1)
J ADJUSTABLE SHELF (3)
K UPPER END MOLDING (2)
M20 TOP MOLDING (1)
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
Nail Holder (provided)
Tape Measure
Now you know
our ABCs.
M46 BASE (1)
N SHELF MOLDING (3)
O SKIRT (1)
P LOWER END MOLDING (2)