Avanti IM44U3S Manual De Instrucciones página 13

Smaller ice setting:
By pressing the "Clean" (-) button, you can decrease the size of the ice cubes. The "ICE" LED (green)
will flash as you lower the ice size and will finally be blinking at the setting of smallest ice size.
Larger ice setting:
By pressing the "Mode" (+) button, you can increase the size of the ice cubes. The "BIN FULL" LED
(red) will flash as the larger size is set and will blink when the setting of largest ice size has been
reached.
After 10 seconds without any operation, the unit will return to the previous mode.
NOTE:
•
If during the ice size adjustment mode the "BIN FULL", "ICE" and "HARVEST" LEDS blink all at
once, this indicates that the unit is in the regular (middle) setting of the ice size.
•
When the machine is in the cleaning stage or ice full stage, the ice size adjustment mode cannot
be accessed
Operating method
1.
Turn on the water tap, let the water trough fill, then press the ON/OFF button on the front panel.
The ice maker will start working automatically.
Ice making stage
2.
After 3 minutes, the machine will automatically go to the ice-making stage, and the sound of water
flowing will be heard.
3. When the batch of ice has been fully formed, ice will automatically be harvested to the ice storage
bin.
4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the bin-full
probe open. The machine stops making ice automatically.
5. The unit will start making ice again after the ice cubes are removed. Then the bin-full probe
swings back to operating position.
Ice harvest stage
13
Bin full stage