Important Safeguides - Avanti IM44U3S Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before the icemaker is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the icemaker, follow basic precaution,
including the following:
Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and
do not use an extension cord.
It is recommended that a separate circuit, serving only your icemaker be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
Never clean icemaker parts with flammable fluids. These fumes can create a fire hazard or
explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity
of this or any other icemaker. The fumes can create a fire hazard or explosion.
Before proceeding with cleaning and maintenance operations, make sure the power line of the
unit is disconnected.
Do not connect or disconnect the electric plug when your hands are wet.
Unplug the icemaker or disconnect power before cleaning or servicing. Failure to do so can result
in electrical shock or death.
Do not attempt to repair or replace any part of your icemaker unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
FOLLOW WARNING CALL OUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
Use two or more people to move and install icemaker. Failure to do so can result in back or other
injury.
To ensure proper ventilation for your icemaker, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 50°F (10
100°F (38°C). This unit must be installed in an area protected from the element, such as wind,
rain, water spray or drips.
The icemaker should not be located next to ovens, grills or other sources of high heat.
The icemaker must be installed with all electrical, water and drain connections in accordance
with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly
grounded in accordance with the National Electrical Code and local codes and ordinances is
required.
Do not kink or pinch the power supply cord of icemaker.
The fuse (or circuit breaker) size should be 15 amperes.
It is important for the icemaker to be leveled in order to work properly. You may need to make
several adjustments to level it.
All installation must be in accordance with local plumbing code requirements.
Make certain that the pipes are not pinched or kinked or damaged during installations.
Check for leaks after connection.
Never allow children to operate, play with or crawl inside the icemaker.
If you use the drainage container, you MUST set the Drain Select switch to OFF or the water can
overflow from the drainage container
Although the unit has been tested at the factory, due to long-term transit and storage, the first
batch of cubes must be discarded.
Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners may
damage or discolor the interior.
Do not use this apparatus for other than its intended purpose.

IMPORTANT SAFEGUIDES

4
°
C) and below

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido