Imetec ECO CYCLONIC Instrucciones De Uso página 13

Cleaning the dust container (15)
• Select the button (6) and disconnect the suction fl exible hose (5) from the appliance.
• Push and lift the dust collection system handle (11) to remove it from the appliance [Fig. G1].
• Push the bottom lid opening button (15B) to open the bottom lid (15C) and empty the holder
[Fig. G2].
Cleaning the cyclone fi lter (15D)
• Remove the dust collection system of the appliance [Fig. G1].
• Push the bottom lid opening button (15B) to open the bottom lid (15C).
• Turn the cyclone fi lter (15D) anti-clockwise to release it from the support [Fig. G3].
• If the cyclone fi lter (15D) is clogged up due to dust, wash it carefully in cold water. Be careful not to
damage the fi lter and allow it to dry completely.
• Allow the fi lter to dry for at least 24 hours after wet cleaning.
• For installation, insert the cyclone fi lter (15D) on the holder so that the fi lter lower side cog (arrow) is
placed in the engraving of the fi lter holder.
• Then turn the cyclone fi lter (15D) clockwise until the cylinder is into place.
• Close the bottom lid (15C).
Replacing the Hepa fi lter (15E) and the sponge fi lter (15F)
• Remove the dust collection system of the appliance [Fig. G1].
• Pull the Hepa fi lter (15E) out of the holder [Fig. G4].
• Pull the sponge fi lter (15F).
• Replace either one or both of them with a new fi lter.
• Reassemble the appliance and put the exhaust fi lter grille (7) back in place and allow the catch to snap
into place.
• Insert the dust collection system before operating it again.
Note: If there is no Hepa fi lter, a security device prevents the dust collection system to be inserted inside
the appliance.
Replacing the exhaust air fi lter (16)
• Press on the catch of the exhaust air fi lter grille (7) and take the fi lter out [Fig. G5].
• Remove the exhaust air fi lter from the appliance.
• Replace the exhaust air fi lter (16) with a new one and put its holder back into place.
Note: Depending on the use of your appliance, the exhaust air fi lter (16) must be replaced annually.
MI000127.indb 11 MI000127.indb 11
All manuals and user guides at all-guides.com
GB
11
7/10/09 7:12:11 PM 7/10/09 7:12:11 PM