Installation Instructions; Freezer Operation - Jocel JCH-100 Manual De Funcionamiento

INSTALLATION INSTRUCTIONS

1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will
cause the compressor to run for long periods.
2. Make sure that sufficient room is provided around the appliance to ensure free air circulation.
Ideally, A space of no less than 10cm must be left around the freezer, and ensure you allow
gaps as shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts
rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and causes
current leakage.
STARTING
1. Insert the plug into the wall socket and switch on the electricity supply，then the Red light is on.
Avoid accidental disconnection by taping over the switch. Green light will glow and the compressor
will start running.
2. You will hear a noise as the compressor starts up. The liquid and gases sealed within the
refrigeration system may also give rise to noise, whether the compressor is running or not which is
quite normal.
3. Do not load the appliance immediately after it is switched on. Wait until the correct storage
temperature has been reached. We recommend that you check the temperature with an accurate
thermometer.
Important Notes:
• If there is a power failure do not open the lid. Frozen food should not be affected if the failure lasts
for less than 20 hours. If the failure is longer, then the food should be checked and eaten
immediately or cooked and then refrozen.
• If you find that the lid of the chest freezer is difficult to open just after you have closed it, don't
worry. This is due to the pressure difference which will equalize and allow the lid to be opened
normally after a few minutes.

FREEZER OPERATION

Temperature adjustment
The temperature of the freezer is adjusted by means of the knob assembled on the thermostat. "1、2、
3、4、5" do not represent a specific temperature. The smaller the No. the higher the temperature,
whereas. So, position "5" is being the lowest temperature.
"OFF"：Forced Shutdown Point
1—5：From -12 ℃ to -30 ℃
All manuals and user guides at all-guides.com
-22-