Tripp-Lite SmartOnline SU5KRT3UHVMB Manual Del Propietário página 34

Optional Connections
3 Remote ON/OFF Configuration
This feature is intended for switching the UPS to Bypass Mode for the Remote OFF configuration, or to Line Mode for the Remote ON
configuration. The 4-pin terminal block supports wire gauges from 14-30 AWG with a strip length of 7 mm. The M2 terminal screws
should be tightened between 0.22~0.25 Nm.
Note: Before activating the Remote ON function, verify the AC input is present and valid.
4
External Battery Connection
Check the Model Specific Accessories section under
Overview for compatible battery packs and maximum quantities
for your UPS system. Ensure that your battery pack matches the
voltage listed next to your UPS battery connector. Adding
external batteries will increase runtime as well as recharge time.
See the battery pack owner's manual for complete installation
and setup instructions. Make sure to attach the ground wire of
the battery cable to the ground screw located near the DC
connector first. Connect the DC connector and make sure it is
fully inserted into their connectors prior to securing it with the
thumbscrew. Small sparks may result during battery connection;
this is normal. Do not connect or disconnect battery packs when
the UPS is running on battery power.
IMPORTANT! In order for the runtime-remaining LCD and the software information screens to accurately predict runtime with
external battery packs connected, you must configure any connected packs using the front panel LCD or Tripp Lite's
External Battery Configuration software. See Configuring External Battery Packs section under Operations.
When installing an external battery pack, observe all external battery warnings in the Important Safety
Instructions section of this manual and follow the external battery pack installation instructions.
REMOTE ON CONFIGURATION:
USER SUPPLIED NORMALLY OPEN SWITCH
REMOTE OFF CONFIGURATION:
USER SUPPLIED NORMALLY OPEN SWITCH
Note: Reinstall the screw if the battery pack connector
is be used to prevent loss of the screw. The Bypass
Power Distribution Module cable has its
own retention screw to secure connector
to the manual bypass PDU.
4
Your model may differ.
34
GND
OFF
ON
VCC
GND
OFF
ON
VCC