Stanley QED 100 Serie Instrucciones De Instalación página 3

4
Cam
5
Bracket
6
Place a bracket as shown at top of door, aligning screw
holes over holes drilled. Fasten with screw in top hole only.
Install Exit Device
Install End Cap
Insert end cap bracket to end of device and mark screw hole
centers. Remove bracket and prepare door as follows: For metal
door, drill & tap 11/64" (4mm) diameter holes for #12-24 machine
screws. For wood door, drill a 1/8? (3mm) diameter pilot hole 1?
deep. Secure bracket to door with appropriate screws.
Install end cap with screws provided.
End Cap
Install Top & Bottom Brackets
7
Top hole
Bracket
Place a bracket as shown at
bottom of door, aligning screw
holes over holes drilled. Fasten
with screw in bottom hole only.
3/20
Remove cover from assembly and remove the end
cap from the end cap bracket.
Cut device as desired if mounting a 45" (1143 mm)
device on a door less than 48" (1219 mm) wide.
Make sure the cut is clean and free from burrs to
allow end cap to fit properly.
Place exit device onto door keeping it horizontally
level and aligning mounting holes with holes drilled.
If you have an exterior trim that has an actuating
shaft or a tailpiece, you must allow shaft or tailpiece
to align inside the cam of exit device. Mount exit
device with appropriate screws, either by engaging
with exterior trim or securing directly onto door.
Note: Sexbolts required for metal door. Sexbolts
highly recommended for wood door, but optional
wood screws are included.
Note: Sexbolts required for metal
door. Sexbolts highly recommended
for wood door, but optional wood
screws are included.
Bracket
Bottom hole