Stanley QED 100 Serie Instrucciones De Instalación página 7

Install Rod Covers
23
Once the device has been tested
and is functioning properly, snap
the rod covers onto the bases.
25
Dogging Device Instruction
For Product with Hex Dogging Device:
Use the dogging device to extend the life of the exit devce during high traffic periods.
To Set Dogging Device:
Depress the push bar, insert the hex wrench and turn clockwise 35°—this will allow
the push bar to remain depressed with the latch detracted.
To Release the Dogging Device:
While keeping push bar depressed, insert hex wrench and turn counter-clockwise
35° to release to normal function.
24
Rod covers
Install Top Rod
Latch
cover
Install Device Cover
Place latch covers over top and bottom latches
aligning screw holes of cover with small holes on
brackets. Once aligned, secure with screws.
Dogging
7/20
Device
cover
Place device cover
over mechanism
and secure with
four small screws.
Hex wrench
35°
35°
counter-clockwise
clockwise