Important Safety Instructions - Makita DHG180 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Rated voltage
Temperature
Air volume
Dimensions (L x W x H)
with BL1860B
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Warning
volts
direct current
Do not use in the rain or leave the heat gun
outdoors while raining.
Hot surfaces - Burns to fingers or hands.
Intended use
This cordless heat gun has been designed for vari-
ous of heating applications such as heat shrinking of
heat-shrinkable wrap or tubes, soldering or de-soldering
electronic components, peeling-off self-adhesive tapes
or stickers, loosen rusted nut or bolt, shaping plastic
parts, drying, melting and unfreezing, etc.
DHG180
550 °C ( 1,022 °F)
200 L/min ( 7.1 cu.ft./min)
168 mm x 79 mm x 251 mm
(6-5/8" x 3-1/8" x 9-7/8")
1.0 - 1.3 kg (2.2 - 2.9 lbs)
BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF / DC18SH
IMPORTANT SAFETY
INSTRUCTIONS
READ THESE INSTRUCTIONS
Hidden areas such as behind walls, ceilings, floors,
soffit boards and other panels may contain flammable
materials that could be ignited by the heat gun when
working in these locations. The ignition of these mate-
rials may not be readily apparent and could result in
property damage and injury to persons.
WARNING:
Extreme care should be taken
when stripping paint. The peelings, residue and
vapors of paint may contain lead, which is poison-
ous. Any pre-1977 paint may contain lead and paint
applied to homes prior to 1950 is likely to contain
lead. Once deposited on surfaces, hand to mouth
contact can result in the ingestion of lead. Exposure
to even low levels of lead can cause irreversible brain
and nervous system damage; young and unborn
children are particularly vulnerable.
Before beginning any paint removal process you should
determine whether the paint you are removing contains
lead. This can be done by your local health department
or by a professional who uses a paint analyzer to check
the lead content of the paint to be removed.
BASED PAINT SHOULD ONLY BE REMOVED
BY A PROFESSIONAL AND SHOULD NOT
BE REMOVED USING A HEAT GUN.
2 ENGLISH
DHG181
D.C. 18 V
Ambient temperature - 550 °C
(1,022 °F)
1: 120 L/min ( 4.2 cu.ft./min)
2: 200 L/min ( 7.1 cu.ft./min)
173 mm x 79 mm x 255 mm
(6-13/16" x 3-1/8" x 10")
1.0 - 1.4 kg (2.2 - 3.1 lbs)
LEAD-