Dry Ironing - Fagor PL-605 S Manual De Instrucciones

interior.qxd 14/4/03 12:31
the use of original spare parts. Any
failure to follow the above instructions
could affect the safe functioning of the
appliance.
• If you decide never to use the appliance
again, cut the lead, first ensuring that
the appliance is unplugged.
• The user should never attempt to
change the cable. If, for any reason, the
cable requires changing, contact a
Technical Assistance Service authorised
by the manufacturer.
• Never hold the appliance under the tap
to fill the water deposit.
• Do not let the mains cable touch the hot
parts of the iron.
• During use, the appliance becomes
extremely hot and can cause serious
burns. Always pick up the iron by the
handle and avoid contact with the
metallic parts and steam.
• Do not turn the iron towards people
when it is expelling steam. This is
extremely dangerous.
• Do not use the iron on very wet fabrics.
• Do not store the iron in a horizontal
position (base down) whilst still hot.
Wait until it has cooled.
• Do not mix stain-removers or similar
products on fabrics to be ironed.
• Unplug the iron when not in use. Never
leave plugged in when not absolutely
necessary.
• The appliance contains a safety device
which, when activated, interrupts the
working of the iron. To reactivate your
iron, contact an authorised Technical
Assistance Service.
4. BEFORE USING YOUR IRON
FOR THE FIRST TIME
Remove all stickers or protective labels
from the base and the body.
Unroll and straighten the electrical cable.
Follow the instructions given in the "Self-
cleaning" section in point "10 –
CLEANING", in order to prepare your
iron for use.
Página 14
All manuals and user guides at all-guides.com
5. INSTRUCTIONS FOR USE

DRY IRONING

1. Place the iron on a stable and heat-
resistant surface.
2. Turn the temperature selector knob (2)
to MIN (Fig. B).
3. Slide the steam control knob (7) to the
dry iron position (Fig. C).
4. Place the iron in an upright position,
resting it on the support base (10).
5. Plug it in and turn the temperature
selector to the desired position. The
pilot light (4) will come on.
6. When the iron has reached the selected
temperature, the pilot light (4) will
switch off. This pilot light may turn on
and off several times while you are
ironing, indicating the cycles of the
thermostat. Remember that if you
change from a higher to a lower
temperature, the pilot light (4) will
remain off until the temperature of the
base (1) has dropped to the selected
level, at which point it will come on
again.
7. When you have finished, turn the
temperature selector to MIN and unplug
the iron. Leave to cool before cleaning
the exterior and storing.
When you are dry ironing, you can use
the spray option at any moment,
providing there is water in the deposit.
(See sections entitled "Spray" and
"Filling the deposit").
6. FILLING THE WATER DEPOSIT
Place the unplugged iron on a stable
surface.
1. Slide the steam control knob (7) to the
dry iron position (Fig. C).
2. Open the lid that covers the water inlet (5).
3. Slowly pour water into the inlet using a
cup (Fig. F). Never pour cleaning
products or solvents into the water
deposit.
4. Check that the water does not exceed
the maximum water level and replace
the cover.
16