Extra Settings - Axxess NITO-01 Instrucciones De Instalación

Installation instructions for part NITO-01
ASWC-1 (sold separately) settings
• The ASWC-1 will auto-detect with no required action from the buttons.
• In order for the ASWC-1 to function, the key must be cycled after it has been programmed.
• To change the source on the aftermarket radio, press the SOURCE button on the steering wheel, and then
press the OK button on the steering wheel.
• The SOURCE button will not function while in certain vehicle screens. If the SOURCE button doesn't function,
press one of the arrow buttons on the steering wheel to bypass the non-functioning screen. Example: While
in an accessory screen, the vehicle screen will display "press brake to start car". The SOURCE button will not
function while in this screen.
Reverse camera operation
• While the vehicle in reverse, the backup camera and 360-view will both be displayed on the radio screen.
This is generated by the vehicle itself; a separate factory module controls the view.
• While in reverse, pressing the PTT (push-to-talk) button on the steering wheel will switch the 360-view to
the passenger-side-view. Pressing the PTT button again will switch back to the 360-view. This replicates
how the factory functions.
Note: There was a CAMERA button in the factory radio that activated the passenger-side-view camera. This
feature will no longer be retained.
Setting the time
• With the vehicle running, turn the radio off.
• Press and hold the PTT (push-to-talk) button on the steering wheel for 10 seconds, and then release.
• The VOLUME-UP and VOLUME-DOWN buttons on the steering wheel will change the hours.
• The SEEK-UP and SEEK-DOWN buttons on the steering wheel will change the minutes.
• Pressing the PTT button will exit this process.
Note: If 10 seconds elapses with no activity, this process will time out.
®
Axxess Integrate
®

Extra settings

axxessinterfaces.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
•
metraonline.com
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION