Extra Settings - Axxess AXTO-NI1 Instrucciones De Instalación

AXSWC (sold separately) settings
• The AXSWC will auto-detect with no required action from the buttons.
• In order for the AXSWC to function, the key must be cycled after it has been programmed.
• To change the source on the aftermarket radio, press the SOURCE button on the steering wheel, and then press the OK button on the steering
wheel.
• The SOURCE button will not function while in certain vehicle screens. If the SOURCE button doesn't function, press one of the arrow buttons on
the steering wheel to bypass the non-functioning screen. Example: While in an accessory screen, the vehicle screen will display "press brake
to start car". The SOURCE button will not function while in this screen.
Reverse camera operation
• While the vehicle in reverse, the backup camera and 360-view will both be displayed on the radio screen. This is generated by the vehicle
itself; a separate factory module controls the view.
• While in reverse, pressing the PTT (push-to-talk) button on the steering wheel will switch the 360-view to the passenger-side-view. Pressing
the PTT button again will switch back to the 360-view. This replicates how the factory functions.
Note: There was a CAMERA button in the factory radio that activated the passenger-side-view camera. This feature will no longer be retained.
Setting the time
• With the vehicle running, turn the radio off.
• Press and hold the PTT (push-to-talk) button on the steering wheel for 10 seconds, and then release.
• The VOLUME-UP and VOLUME-DOWN buttons on the steering wheel will change the hours.
• The SEEK-UP and SEEK-DOWN buttons on the steering wheel will change the minutes.
• Pressing the PTT button will exit this process.
Note: If 10 seconds elapses with no activity, this process will time out.
AxxessInterfaces.com

EXTRA SETTINGS

© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
AXTO-NI1
I N S TA L L AT I O N I N S T R U C T I O N S
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at 1-800-253-TECH, or email at
techsupport@metra-autosound.com. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.
K
®
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
P
OWER
REV. 1/23/20 INSTAXTO-NI1