Main Brush Belt Replacement; Tools Required - Tennant S6 Manual Del Operario

1) Remove the rear hopper
2) Take the filter out
3) Blow compressed air into the side of the filter (at a pressure of 87 psi
at the most). Safety glasses required
4) Reinstall the filters and the rear hopper.

MAIN BRUSH BELT REPLACEMENT

TOOLS REQUIRED: 3mm Allen Wrench, 4mm Allen
Wrench, 5mm Allen Wrench, 8mm Socket
Parts List: MTCG00019 Belt
1) Remove top cover from machine by removing the four screws.
2) Unplug the Red\Black battery connector.
3) Remove right side cover.
4) Remove the mounting bolt for the side brush arm by using a 5mm
Allen wrench.
5) Remove side brush arm.
6) Loosen (do not remove) the two motor mounting bolts (8mm) and pivot
motor counter-clockwise to loosen the belt tension.
7) Remove old belt and install new belt onto the pulleys.
8) Tighten belt tension by pivoting the motor clockwise. Tighten the two
mounting bolts.
9) Reassemble side brush arm support.
10) Reassemble covers and reconnect the battery.
11) Test for proper operation.
EN
8