Machine Maintenance; Side Brush Replacement; Main Brush Replacement; Cleaning And Servicing The Filters - Tennant S6 Manual Del Operario

MACHINE MAINTENANCE:

All service performed should be completed by persons who understand
the machine or an AUTHORIZED SERVICE CENTER. It is recommended
that only authorized repair parts be used for service.
FOR SAFETY: When servicing the machine disconnect the battery
connection and battery charger plug before working on the machi-
ne.
MAINTENANCE CHECK LIST
The belts for slackening
The tightness of nuts and screws
The brushes for wear
The gaskets for wear and leakages
If all the functions are in working order
Empty hopper
Remove and shake pre-filter
Check main filter

SIDE BRUSH REPLACEMENT:

Raise the front part of the machine.
Press in the 2 tabs (indicated by the arrows) and pull off the brushes.
Slide the new brush until it locks into place.

MAIN BRUSH REPLACEMENT:

X
X
X
X
X X X X X X
X
X
X

CLEANING AND SERVICING THE FILTERS:

The filters are very important components of the machine and essential
for correct operation. Proper filter maintenance will allow you to obtain
the best performance from your machine.
Pre-Filter
Clean Daily
1) Remove the debris hopper to access the pre-filter
2) Release the two metal retaining clip arms that secure the pre-filter in
place. Hinge the retaining clip arms outward and remove the pre-filter.
3) Shake the pre-filter into a debris receptacle.
4) Replace the pre-filter and secure with retainer clips.
Main Filter
The Main filter can be cleaned in any of the following three ways:
1) by means of the automatic filter shaker:
During operation, the machine will automatically activate the filter shaker
every 3 minutes.
2) by means of manually activating the filter shaker:
Just a simple command is needed to keep the filter in perfect working
order: press the button marked 'E' and hold it downfor a few seconds.
Repeat this operation 4 or 5 times.
Remember that the cleaner the filter, the better the results of your
cleaning session. It is recommended to carry this good idea to use the
manual filter shaker more frequently.
3) by manually cleaning the filter:
Manually clean the filter when the filter shaker is not enough to keep the
filter clean and/or every 20 hours of work. Before carrying out any kind of
procedure on the machine, make sure it is turned off and that all functions
are deactivated.
EN
► Tilt the machine backwards until the handle is touching the
ground and the main brush is easily reached.
► Manually turn the brush until a black button is seen on the right
hand side of the brush core.
► Press the button and push to dis-engage the brush.
► Insert the new brush following the guide.
7