HTW INNOVA HTWS026INNR32-INT Manual De Usuario E Instalacion página 34

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Clean and maintenance
2. Remove IFD module
Pull out the IFD module by pressing the buttons at the left and right ends.
3. Clean IFD module
Clean IFD module by vacuum cleaner or water rinsing. If the IFD module is too dirty such
as serious oil contamination, it should be cleaned with warm water (below 45℃ ) dissolved
with neutral detergent. After that dry it in a cool place.
4. Installation IFD module
After the IFD module is dried, push the IFD module to slot of the air conditioner, then cover
the panel.
■ For the models with healthy filters, please refer to below steps to clean healthy filters.
(1) Remove the health filter from the air filter along the arrow direction. The health filters
can be installed in the opposite way.
(2) Clean healthy filter by vacuum cleaner or water rinsing. If the healthy filter is too dirty
such as serious oil contamination, it should be cleaned with warm water (below 45℃ )
dissolved with neutral detergent. After that dry it in a cool place.
(3) Clean the surface dust with a soft brush and then clean it with a blower for maintenance.
NOTE:
The filter should be cleaned every three months. If there is much dust in the operation
environment, clean frequency can be increased.
After removing the filter,do not touch fins to avoid injury.
Do not use fire or hair dryer to dry the filter to avoid deformation or fire hazard.
IFD module Healthy filters
IFD module
Health filters
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Innova htws035innr32-int

Tabla de contenido