Programming The Com Mute Key - RadioShack 15-2138 Manual Del Propietário

All manuals and user guides at all-guides.com
RS 8in1 Kameleon OM rev
6. Exit programming by pressing
last-selected device menu screen.
7. To test the power macro, first make sure all home theater devices
selected in step 4 are turned on.Aim the remote control at the
devices and press MY SYSTEM once, followed by PWR once. The
devices should turn off in this order: Satellite Receiver, DVD Player,
Audio Receiver, and TV.
To turn on the devices on again in the same order as above, press
PWR once.
P T COM MUTE K
ROGRAMMING HE
If desired, a two-state rotating macro can be programmed onto the COM
MUTE key, so a key press will drop volume (in the CBL, SAT, TV, VCR, or
AUX mode) to a preset level during a commercial. When the program
resumes, another key press will raise it back to the original level.
1. Press and hold P until the bottom IR segment flashes twice.
The program keys will appear:
2. Press above MACRO once.The Macro programming screen will appear:
3. Press COM MUTE once.The last-selected device menu screen, including
, will be displayed.
4. Enter the first macro sequence by pressing TV once, then press VOL
four times (to lower the volume four steps).
5. To save the macro, press and hold P until the bottom IR segment
flashes twice. The program keys will appear again.
6. To program the second macro, repeat steps 2 through 5, but substitute
L M
VOL for VOL
this time (to raise the level four steps).
7. Exit programming by pressing
last-selected device menu screen.
10/9/03 4:11 PM Page 27
O '
WNER S
once. The display will return to the
EY
once. The display will return to the
continued on next page...
Using Macros 27
M
ANUAL
M