Emerson FloBoss 103 Instrucciones De Seguridad Para De Uso página 6

Ocultar thumbs Ver también para FloBoss 103:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
Safe Use Instructions - FloBoss 103
The terminals are labeled CHG+ for positive power
connection and CHG- for negative power connection
on a label on the termination board. See Figure 4.
Figure 4. Termination Board
6. The FloBoss 103 ships with the NORM/RESET
jumper in the NORM position, and the ON/OFF
jumper in the OFF position.
To apply power to the FloBoss 103:
Unscrew the cover clamp at the base of the front
end cap (LCD end). See Figure 5.
Figure 5. Cover Clamp Assembly
Unscrew the front end cap cover.
Place the power jumper (located on the LCD if
installed or located at J1 on the Battery Charger
Board) in the ON position. See Figure 6 and
Figure 7.
All manuals and user guides at all-guides.com
After the FloBoss 103 completes start-up
diagnostics (RAM and other internal checks), the
optional LCD displays the date and time to indicate
that the FloBoss has completed a valid reset
sequence. If the LCD does not come on, perform
trouble-shooting for possible causes (see Step 9).
7. The FloBoss 103 must be configured before it is
calibrated and placed into operation. Configuration
must be performed using ROCLINK 800 software,
which runs on an IBM-compatible personal
computer. The personal computer is normally
connected to the LOI port of the flow computer to
transfer configuration data into the FloBoss 103,
although much of the configuration can be done off-
line and later loaded into the FloBoss.
Figure 6. Front End of FloBoss 103 (with LCD)
Replace the front end cap cover (LCD end) and
cover clamp.
Figure 7. Front End of FloBoss 103 (without LCD)
Form A6150
Page 4
NORM/
RESET
Jumper
ON/OFF
Jumper
ON/ OFF
Jumper

Publicidad

Tabla de contenido
loading

Tabla de contenido