About This Document; General Safety Precautions; Electrical Connection - STEINEL DL Vario Quattro S Manual Del Usuario

GB

1. About this document

Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or
in part only with our consent.
– Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in the
...
document.

2. General safety precautions

Disconnect the power supply before
!
attempting any work on the unit.
• During installation, the electric power cable being
connected must not be live. Therefore, switch off
the power first and use a voltage tester to make
sure the wiring is off-circuit.
• Installing the sensor-switched light involves work
on the mains supply voltage. This work must
therefore be carried out professionally in accord-
ance with national wiring regulations and electrical
operating conditions. ( e.g.: DE: VDE 0100,
AT: ÖVE / ÖNORM E8001-1, CH: SEV 1000 )
• Only use genuine replacement parts.
• Repairs may only be made by specialist work-
shops.
3. DL Vario Quattro S
Proper use
– The Vario Quattro is a sensor-switched light for
indoor and outdoor ceiling mounting.
The sensor-switched light is equipped with four
pyro sensors that detect the invisible heat emitted
by moving objects ( people, animals, etc. ). The
heat detected in this way is converted electronically
into a signal that switches the light ON. Heat is not
detected through obstacles, such as walls or panes
of glass, and will therefore not activate the light.
Note:
The light's shade is susceptible to scratching. The
light must not be installed near radiant heaters.
Package contents ( Fig. 3�1 )
– Sensor-switched light
– 3 spacers
– 3 wall plugs
– 3 screws
– Retaining strap
Product dimensions ( Fig. 3�2 )
Product components ( Fig. 3�3 )
A Light
B Reach adjustment
C Connecting terminal
D Twilight setting
E Time setting
F Basic light level
G Ceiling mount
Detection zone ( Fig. 3�4 )
Luminous intensity distribution ( Fig� 3�5 )

4. Electrical connection

Wiring diagram ( Fig. 4.1 )
The mains supply lead is a 3-core cable ( max. lead
diameter 19 mm ):
= phase conductor ( usually black, brown or grey )
L
N = neutral conductor ( usually blue )
PE = protective-earth conductor ( green/yellow )
If you are in any doubt, identify the conductors
using a voltage tester; then disconnect from the
power supply again. Connect the phase conduc-
tor ( L ) and neutral conductor ( N ) to the terminal
block. Insulate protective-earth conductor ( PE )
and place it next to terminal block.
Important:
Mixing up the connections will produce a short
circuit in the product or your fuse box. In this case,
you must identify the individual conductors once
again and reconnect them. A mains power switch
for turning the unit ON and OFF may of course be
installed in the mains supply lead.
The light source of this luminaire cannot be repla-
ced. If the light source needs to be replaced (e.g.
at the end of its service life), the complete luminaire
must be replaced.
- 12 -