Recording Modes And Recordable Time Available For The Motion Picture - Panasonic VDR-D310PL Instrucciones De Funcionamiento

All manuals and user guides at all-guides.com
LSQT1150.book 47 ページ ２００７年１月１９日 金曜日 午前９時２７分
≥ When about 5 minutes have passed without any operation in recording pause, the unit automatically
turns off to prevent the battery from running down. When you want to use the unit, turn it on again.
This setting can also be set to [OFF]. (l 117, [POWER SAVE])
Screen indications in the video recording mode
A Recording mode
B Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0min]
flashes red.)
C Recording time elapsed
≥ The maximum number of scenes on a disc (per side): 999 (Even if there is remaining capacity for
recording on a disc, you may not be able to record 999 scenes.)
≥ Maximum number of dates on a disc (per side): 99 (Even if scenes are recorded on the same day,
they may be grouped on a different recording date.) (l 67)
≥ Sound is recorded in Dolby Digital from the internal stereo microphone on the front of the unit. Take
care not to block this microphone.
≥ Each time the unit enters the recording pause mode, the counter display will be reset to "0h00m00s".
≥ While motion picture recording is in progress, the recording will not stop even if the LCD monitor is
closed and the viewfinder is retracted.
≥ While "WRITING CONTROL DATA TO THE DISC. DO NOT SHAKE THE UNIT." is displayed, do not
disconnect the AC adaptor or remove the battery as doing so may make the disc unusable.
≥ While motion picture recording is in progress, do not disconnect the AC adaptor or remove the
battery. If you do, a repair disc message may be displayed when the power is turned back on.
(l 122, About recovery)
The ACCESS/PC lamp lights immediately after recording finishes. While it lights, the disc is rotating
and disc information is being recorded. If you run while holding the unit or swing it, the recorded
images may be distorted so do not strongly shake or cause impact to it.
Recording modes and recordable time available for the
motion picture
Changing the recording mode of the motion picture.
Press the MENU button, then select
[BASIC] # [REC MODE] # desired
item and press the joystick.
Recording
A
SP 0h00m10s 0h00m10s 0h00m10s
R 30min R 30min R 30min
B
C
MENU
47
LSQT1150