Troubleshooting - Panasonic VDR-D310PL Instrucciones De Funcionamiento

All manuals and user guides at all-guides.com
LSQT1150.book 127 ページ ２００７年１月１９日 金曜日 午前９時２７分

Troubleshooting

Problem
≥ Is the battery fully charged?
This unit cannot be ≥ The battery protection circuit may have operated. Attach the
turned on.
≥ Is the LCD monitor opened or the viewfinder extended?
≥ If you do not use the unit for approximately 5 minutes, the
This unit is turned off
automatically.
≥ Is the battery low?
This unit does not stay
on long enough.
A clicking sound is heard
when the power is turned ≥ This is the sound of the lens moving and is not a malfunction.
off.
≥ Is the battery fully charged?
≥ Are you using the battery in an extremely cold place?
Battery runs down
quickly.
≥ Has the battery worn out?
≥ The unit cannot be operated unless you open the LCD monitor
This unit cannot be
operated though it is ≥ Press the RESET button. (l 130) If normal conditions are not
turned on.
This unit does not
operate normally.
≥ Has the demonstration started?
The screen has changed
suddenly.
Check points
# Charge the battery using the AC adaptor. (l 28)
battery to the AC adaptor for 5 to 10 seconds. If the unit still
cannot be used, the battery is faulty.
power is automatically turned off to conserve the battery
charge. To resume recording, turn the power back on.
The power will not turn off automatically when the power save
function (l 117) is set to [OFF].
# If the remaining battery power indication is flashing or the
message "LOW BATTERY." is displayed, the battery has run
down. Charge the battery. (l 28)
# Charge it with the AC adaptor. (l 28)
# The battery is affected by ambient temperature. In cold places,
the operating time of the battery becomes shorter.
# The battery has a limited life. If the operating time is still too short
even after the battery is fully charged, the battery has worn out
and can no longer be used.
or extend the viewfinder.
restored yet, remove the battery or AC adaptor, wait about 1
minute and then reconnect the battery or AC adaptor. Then
about 1 minute later, turn on the power again. (Conducting the
above operation when the access lamp is on may destroy the
data on the disc or card.)
# If you set [DEMO MODE] to [ON] without inserting a disc or a
card in video recording mode or picture recording mode, the unit
is automatically set to the demonstration mode for introducing its
functions. Normally this should be set to [OFF]. Press the MENU
button, then select [SETUP] # [DEMO MODE] # [OFF] and
press the joystick.
Others
127
LSQT1150