Inspecting The Blades - Toro 54610 Manual Del Operador

Inspecting the Blades

Service Interval: Before each use or daily
Yearly
Replace the blades when the machine hits a solid
object or if the blades are damaged or bent. Use only
genuine Toro replacement blades.
Important:
Always wear padded gloves when
working with the blades.
WARNING
A worn or damaged blade can break, and a
piece of the blade could be thrown toward you
or bystanders, resulting in serious personal
injury.
• Inspect the blades periodically for wear or
damage.
• Replace a worn or damaged blade.
Note:
Maintain sharp blades; sharp blades help
the machine run smoothly and cut cleanly without
excessively tearing or shredding the turf.
1. Refer to Preparing for Maintenance (page
2. Tip the machine onto its left side until the upper
handle rests on the ground.
Important:
Before tipping the machine to
inspect or replace the blades, allow the fuel
tank to run dry through normal use. If you
must tip the machine prior to running out
of fuel, use a hand fuel pump to remove
the fuel. Tip the machine onto its left side
(exhaust guard down, oil filter up) so that oil
does not leak into the air filter.
3. Inspect the scarifier roller shaft for bent or
damaged blades in need of replacement, if any
need to be replaced contact your Authorized
Service Dealer.
4. Remove any grass or debris that may be
wrapped around the ends of the shaft assembly.
18).
21