The pump can run against a restricted discharge without damage to the pump.
Keep pump clean and in a well maintained condition at all times. Pump should be thoroughly cleaned for
summer storage.
If float becomes stuck, remove the float access cover on the bottom of the unit. Remove the cover by turn-
ing it towards the "OPEN" arrow as indicated on the cover. Clean as needed, then reinstall access cover.
This pump has an internal vent hole to prevent an air-lock condition. Periodically the vent hole can become
obstructed and will require cleaning according to the following steps:
1.
Disconnect the pump from electrical service.
2. Loosen and remove the five screws from the outer blue cover (four
shown).
3. Remove the outer cover.
4. Clean debris from the vent hole.
5. Re-install the outer cover and screws.
6. Re-connect the pump to electrical service.
Replacement Parts List
Item
Part No.
1.
177343
2.
177344
3.
177345
Description
Garden hose adapter
Float/Stem assembly
Float Access Cover
Replacement Parts List
4
2
1
2
3
MAINTENANCE
2
7