Waeco CombiCool CAB-40B-PB30 Instrucciones De Uso página 24

cab-40_40B_55.book Seite 24 Mittwoch, 29. August 2007 12:26 12
Using the cooler
6.1 Operating with 220 V – 240 V
Check that the voltage specification on the type plate is the same
as that of the power supply.
➤ Plug the earthed plug (3 3, page 4) into a properly installed safety plug
socket.
➤ Set the thermostat control (2 2, page 3) to "7" (maximum cooling
capacity).
➤ Wait until the temperature in the cooler has dropped.
➤ Set the thermostat control (2 2, page 3) to the desired temperature
range.
➤ To switch off the cooler, set the thermostat control (2 2, page 3) to "0"
and pull out the plug.
6.2 Operating with 12 V DC
You cannot set the temperature with the thermostat control during
battery operation. The device is simply switched on and starts
cooling.
Disconnect the cooler from the battery when the engine is not
running as otherwise the battery will be completely run down and
the vehicle might not start.
➤ Ensure the 12 V socket in the vehicle is protected by a fuse with a
maximum rating of 15 A.
➤ Ensure that the thermostat control for 220 V – 240 V operation (2 2,
page 3) is in the "0" position.
➤ Insert the plug of the connection cable (3 2, page 4) into the 12 V DC
socket (e.g. cigarette lighter).
The polarity is optional.
➤ To switch off the cooler, pull the plug out of the socket.
24
All manuals and user guides at all-guides.com
CombiCool