Series Operation; Ups Operation - Westinghouse iGen1000s Manual Del Usuario

Example:
Tool or Appliance
TV (Tube Type)
RV Refrigerator
Radio
Light (75 Watts)
Coffee Maker
Total Running Watts
Highest Peak (Starting) Watts
Total Watts Needed
*Wattages listed are approximate. Verify actual wattage.

SERIES OPERATION

Two iGen1000s Power Stations can be
connected to provide continuous power with
twice the battery capacity.
Note: During series operation, do not connect
either of the Power Stations to the
power grid with an AC charging cable
to prevent activating the over-current
protection.
1. Charge both Power Stations to 100%.
Note: Do not charge more than two Power
Stations at the same time to prevent
an excessive load on your home power
grid.
2. Connect an AC cable to any AC outlets on the
Master unit and the other side of the cable to
the AC charging input port of the Active unit
as shown.
100% 100%
Main Unit
3. Power both units ON, then push the AC ON/
OFF button on both units to turn AC power
ON.
Running Peak
Watts* (Starting)
Watts*
300
180 600
200
300
600
1580 Total 600 Highest
Running Peak
Watts* (Starting)
Watts*
Active Unit
4. Connect devices to the AC outlets on the
Active unit and enjoy twice the battery life.
Note: Do not connect any electrical devices
to the primary unit while in series
0
operation.

UPS OPERATION

0
0
The iGen1000s can be used as a temporary
Uninterruptible Power Supply (UPS) to provide
0
continuous power in case of a power outage.
You can use the iGen1000s AC outlets while
the Power Station is connected to a wall socket
with the AC power supply (the AC power comes
1580
from the power grid, not the battery). When the
+ 600
power grid suddenly loses power, the connected
device can automatically switch to iGen1000s
2180
battery power in approximately 30ms to ensure
your work is not interrupted.
Note:
Do not connect devices with high
uninterrupted
requirements. Please perform multiple
tests to confirm compatibility before
connecting devices, such as data
servers
iGen1000s.
Because the AC outlets of the iGen1000s are
in a double blade, ungrounded configuration,
it is recommended to use the UPS function
of iGen1000s for temporary emergency use
only.
DO NOT use electric devices with bare metal
when charging to avoid the risk of electric
shock.
Westinghouse Outdoor Power Equipment, LLC | 11
power
and workstations
NOTICE
supply
to the