Connect The Ethernet Cable - Cognex In-Sight CIO-MICRO Guia De Inicio Rapido

6
Connect an RJ-45 LAN Cable
If connecting the vision system to an Ethernet network, plug a LAN cable
(RJ-45 connector) into the I/O module's LAN port and connect the other end
of the cable to a switch/router or PC, as applicable.
7
Connect the I/O Module Cable
If using the In-Sight Micro vision system's acquisition trigger or high-speed
outputs, complete the following steps.
1. Connect the I/O Module cable's M8 connector to the vision system's I/O
connector.
2. Plug the I/O Module cable's DB15 connector into the I/O module's I/O
connector.
8

Connect the Ethernet Cable

1. Connect the Ethernet cable's M12 connector to the vision system's PoE
connector.
2. Connect the Ethernet cable's RJ-45 connector to the I/O module's PoE
port.
3. Restore power to the I/O module's 24VDC power supply and turn it on if
necessary.
4. Use In-Sight Explorer to confi gure the vision system and I/O module. For
more information, refer to the In-Sight
from the Help menu or by pressing the F1 key.
Explorer Help, which is available
®
8