Silvercrest SHBS 3.7 B1 Instrucciones De Servicio página 88

Only connect the power unit to a properly installed,
easily accessible wall socket, the voltage of which cor-
responds to the specifications on the rating plate. The
wall socket must continue to be easily accessible after
the device is plugged in.
Ensure that the cable cannot be damaged by sharp
edges or hot surfaces.
Ensure that the cable is not trapped or crushed.
When removing the power unit from the wall socket,
always pull the power unit and never the cable.
Pull the power unit out of the wall socket, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the cable,
... before you clean the device and
... during thunderstorms.
To avoid any risk, do not make modifications to the de-
vice. Repairs must be carried out by a specialist work-
shop or the Service Centre.
DANGER from batteries
Protect the battery against mechanical damages. Fire
hazard!
Do not expose the device to direct sunshine or heat.
The ambient temperature should not be lower than
-10 °C and higher than +40 °C.
The charge contacts on the device must not be connect-
ed by metallic objects.
The battery may only be charged with the original ac-
cessory (power unit).
86
GB