Uline SHARK NAVIGATOR LIFT-AWAY Guia De Inicio Rapido página 2

OPERATING ISSUE
Motorized brush roll is
jammed or has shut off.
Vacuum turns off on its
own, or indicator light
flashes red.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 6
TROUBLESHOOTING CONTINUED
Immediately turn off and unplug vacuum, disconnect the nozzle and
remove blockage before reconnecting and turning vacuum back on.
Refer to Checking for Blockages.
This vacuum is equipped with a motor-protective thermostat.
If vacuum overheats, the thermostat will automatically turn the suction
motor off. Perform the following steps to restart the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters.
3. Check for blockages in hose, accessories and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and restart the unit with the Power/Surface switch.
1-800-295-5510
uline.com
RECOMMENDATIONS
(See instructions page 5)
0820 TH-8831