DeWalt DWE4212 Manual De Instrucciones página 39

adjustment options
For guard adjustment, the guard release lever
one of the alignment holes 15
a ratcheting feature. Your grinder offers two options for
this adjustment.
• one-touch TM : In this position the engaging face is
slanted and will ride over to the next alignment hole
when guard is rotated in a clockwise direction (spindle
facing user) but self-locks in the anti-clockwise direction.
Two-touch : In this position the engaging face is
• TM
straight and squared off. It will NOT ride over to the next
alignment hole unless guard release lever is pressed and
held while simultaneously rotating the guard in either a
clockwise or anti-clockwise direction (spindle facing user).
One-Touch TM
setting guard adjustment options
To adjust the guard release lever
adjustment option:
1. Remove screw using a T20 bit.
19
2. Remove the guard release lever taking note of the
spring position. Choose the end of the lever for the
desired adjustment option. One-touch will use the
slanted end of the lever 10
holes on the guard collar. Two-touch will use the
16
squared end to engage the alignmnet holes
guard collar.
3. Replace the lever, positioning the chosen end under the
spring 14 . Ensure the lever is in proper contact with
the spring.
4. Replace screw and torque to 2.0-3.0N-m. Ensure proper
installation with spring return function by depressing
guard release lever 10 .
Fig. C
14
10 engages
on the guard collar using
Two-Touch TM
10 for desired
to engage the alignment
on the
16
19
10
Mounting guard (Fig. D)

CAUTION: Prior to mounting guard, ensure the screw,
lever, and spring are fitted correctly before mounting
the guard.
1. With the spindle facing the operator, press and hold the
guard release lever .
10
2. Align the lugs on the guard with the slots
14
the gear case.
3. Push the guard down until the guard lugs engage and
rotate them in the groove on the gear case hub. Release
the guard release lever.
4. To position the guard:
one-touch TM : Rotate the guard clockwise into the
desired working position. Press and hold the guard
release lever 10 release lever to rotate the guard in the
anti-clockwise direction.
Two-touch : Press and hold the guard release
TM
lever . Rotate the guard clockwise or anti-clockwise
10
into the desired working position.
NoTE: The guard body should be positioned between
the spindle and the operator to provide maximum
operator protection.
The guard release lever should snap into one of the
alignment holes on the guard collar. This ensures
16
that the guard is secure.
5. To remove the guard, follow steps 1–3 of these
instructions in reverse.
Fig. D
16
15
Flanges and Wheels
Mounting Non-Hubbed Wheels (Fig. E)

WARNING: Failure to properly seat the flange/ clamp
nut/ wheel could result in serious injury (or damage to
the tool or wheel).

CAUTION: Included flanges must be used with
depressed center Type 27 and Type 42 grinding wheels
and Type 41 cutting wheels. See the accessories
Chart for more information.
ENglIsh
on
15
14
10
37