Acoustic Signals; How To Activate The Acoustic Signal For The End Of Programme - AEG FAVORIT 55700VI1P Manual De Instrucciones

10 www.aeg.com
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.
6.4 The rinse aid empty
notification
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press .
• The indicators
off.
• The indicator
flash.
• The display shows the current
setting:
All manuals and user guides at all-guides.com
= level 4.
again and again to change
and
, , and
, and
continues to
= the rinse aid
dispenser is activated (factory
setting).
3. Press to change the setting.
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm
the setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
off.
until
• The indicator
flash.
• The display shows the current
setting:
go
3. Press
to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm
the setting.
and until
, , and
, and go
continues to
= Acoustic signal off.