The Rinse Aid Dispenser; Acoustic Signals; How To Activate The Acoustic Signal For The End Of Programme - AEG FAVORIT 78420 VI0P Manual De Instrucciones

10 www.aeg.com
• The acoustic signals sound: e.g. 5
intermittent signals = level 5.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.

6.3 The rinse aid dispenser

The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
Use of rinse aid and multi-
tablets together
When you activate the option Multitab,
the rinse aid dispenser no longer
releases rinse aid. However if you are
using multi-tablets and the drying results
are not satisfactory, we suggest to use
multi-tablets and rinse aid together. In
this case you have to activate the rinse
aid dispenser.
The rinse aid dispenser will remain
activated until you modify the setting
again
How to activate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
to flash and the display is blank.
2. Press
• The indicators
again and again to change
and
, and
.
and
• The indicator
flash.
• The display shows the current
setting:
deactivated.
3. Press
= rinse aid dispenser activated.
4. Press the on/off button to confirm
the setting.
5. Adjust the dosage of rinse aid.
6. Fill the rinse aid dispenser.

6.4 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs and
when you set the level of the water
softener. It is not possible to deactivate
these acoustic signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
to flash and the display is blank.
2. Press
• The indicators
• The indicator
flash.
• The display shows the current
until
setting:
start
3. Press
= Acoustic signal on.
4. Press the on/off button to confirm
go off.
the setting.
continues to
= rinse aid dispenser
to change the setting.
and
, and
.
and
continues to
= Acoustic signal off.
to change the setting.
until
start
go off.