Electrical Connection - Beko CTB 6250 W Manual Del Usuario

3 Installation
Closing Element
• The space between the edge of the hood and
the rear wall can be closed by applying the ele-
ment 20 provided, using the screws supplied for
this purpose
3.2 Connection
3.2.1 Ducted Version Air Exhaust
System
When installing the ducted version, connect the
hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left
to the installer
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet
• Fix the pipe in position using sufficient pipe
clamps (not supplied)
• Remove possible charcoal filters
Hood / User Manual
All manuals and user guides at all-guides.com
3.2.2 Recirculation Version Air
Outlet
• Cut a hole ø 125 mm in any shelf that may be
• Insert the reducer flange 9 on the hood body
• Connect the flange to the outlet on the shelf
• Fix the pipe in position using sufficient pipe
• Fix the air outlet grid 8 on the recirculation air
• Ensure that the activated charcoal filters have

3.2.3 Electrical Connection

• Connect the hood to the mains through a two-
• When opening the sliding carriage for the first
positioned over the hood
outlet
over the hood by using a flexible or rigid pipe
ø120 mm
clamps (not supplied)
outlet by using the 2 screws 12e (2,9 x 9,5) pro-
vided
been inserted
pole switch having a contact gap of at least
3mm
time after installing the hood, pull it out briskly
until it clicks
126
9 / EN