Publicidad
12
12
31G
P
A
These edges
should be even.
Fasten an END MOLDING (T) to the RIGHT END (A). Tighten two HIDDEN CAMS.
Fasten the other END MOLDING (T) to the LEFT END (B). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten two CORNER BRACKETS (31G) to the BASES (P and Q) and BOTTOM (F). Use eight BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten two METAL BRACKETS (4G) to the BOTTOM (F). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the BRACKETS are even with the edges of the BOTTOM.
Fasten the BASE (O) to the CORNER BRACKETS (31G) and METAL BRACKETS (4G). Use six BLACK 9/16" LARGE HEAD
SCREWS (1S).
Page 16
4G
F
T
BLACK 9/16" LARGE HEAD SCREW
(18 used in this step)
www.sauder.com/services
Q
O
B
Use the small holes in
this MOLDING (T).
Maximum
210 degrees
Minimum
190 degrees
1S
31G
These edges
should be even.
T
Arrow
414723
Publicidad
