Publicidad
14
14
The BACK should be against
the bottom surface of the TOP.
1N
NAIL
(45 used in this step)
Unfold the BACK (J) and lay it over your unit.
Fasten the BACK (J) to your unit using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (C), SMALL UPRIGHT (D), and SHELF (G).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
Push the FOOT (23E) into the hole in the BOTTOM (F).
Page 18
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up over the URIGHT (C),
SMALL UPRIGHT (D), and SHELF (G).
www.sauder.com/services
J
F
23E
414723
Publicidad
