Tabla de contenido
Publicidad
17
17
BLACK 1-7/8" FLAT HEAD SCREW
(1 used into a stud in your wall)
BLACK 9/16" LARGE HEAD SCREW
(1 used into the top of your unit)
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice in the
END (A) and UPRIGHT (C). Set the ADJUSTABLE SHELVES (L) onto the METAL PINS.
We recommend using the SAFETY BRACKET (1G) for added stability. Use a BLACK 9/16" LARGE HEAD SCREW (1S) into the
top of the unit and a BLACK 1-7/8" FLAT HEAD SCREW (2S) into a stud in your wall.
Apply the WARNING LABEL (1L) to the TOP (E). You should be able to read the label when the TV is removed from the unit. When
the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
414723
2S
1G
1S
1L
www.sauder.com/services
Never use this furniture with a TV that is
too large or too heavy. Severe injury or
death can occur. The TV and furniture
will be unstable and may tip.
- The TV must weigh less than 50 lbs.
- The base of the TV must be able to sit
completely on this shelf.
E
L
L
C
WARNING
A
1R
2R
(8 used)
Page 21
Publicidad
Tabla de contenido
