Tabla de contenido
Publicidad
5 5
Fasten the MOLDINGS (M and N) to the TOP (E). Tighten two TWIST-LOCK
414723
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain
fully inserted in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver
as tight as possible.
Dowel end
M
www.sauder.com/services
®
FASTENER
E
®
FASTENERS.
N
Page 9
Publicidad
Tabla de contenido
