English
Setting the Paper Width to 82.5 mm
To change the paper width to 82.5 mm, remove the paper guide installed in
groove a in illustration E.
1.
Make sure the printer is turned off.
2.
Open the paper loading cover by pulling up the cover open lever. (See
illustration D.)
3.
Remove the screw fixing the paper guide installed in groove a in
illustration E. (See illustration F.)
4.
Remove the paper guide by pulling it up. (See illustration F.)
Setting the Paper Width to 79.5 mm
To change the paper width to 79.5 mm, remove the paper guides installed in
grooves a and c, and install one of them in groove b in illustration E.
1.
Remove 2 paper guides by following the same steps as "Setting the Paper
Width to 82.5 mm."
2.
Install one of the removed paper guides in the groove b in illustration E so
that the projections of the paper guide are aligned with the holes along the
groove.
3.
Fix the paper guide with the screw.
Connecting the Cables
CAUTION:
For a serial interface, use a null modem cable.
For a USB interface, do not turn on the printer before installing the printer driver.
Note:
Available interfaces vary by the printer model. For the positions and shapes of the
connectors on the back of the printer, see illustration G.
1.
Make sure the power switch is off.
2.
Connect the power cord to the power supply connector.
3.
Connect each interface cable to the printer. When using the USB interface,
install the cable hook and fix the USB cable to prevent it from coming off. (See
illustration H.)
4.
Connect the interface cable to the computer.
5.
Insert the power cord plug into a socket.
Loading Paper
When the Paper LED is on, follow the steps below to load paper.
CAUTION:
Be sure to use the specified paper.
Set the paper width properly for the paper you want to use. For how to set the
paper width, see "Setting the Paper Width" on page 9.
1.
Turn on the printer.
2.
Open the paper loading cover by pulling up the cover open lever. (See
illustration D.)
10 TM-L500A User's Manual
All manuals and user guides at all-guides.com