Connecting The Cables; Loading Paper - Epson TM-L500A Ticket Manual Del Usuario

English
Setting the Paper Width to 79.5 mm
To change the paper width to 79.5 mm, remove the paper guides installed in
grooves b and d, and install one of them in groove c in illustration D.
1. Remove the two paper guides by following the same steps as "Setting the
Paper Width to 82.5 mm."
2. Install one of the removed paper guides in the groove c in illustration D so
that the projections of the paper guide are aligned with the holes along the
groove.
3. Fix the paper guide with the screw.
Setting the Paper Width to 50.8 mm
To change the paper width to 50.8 mm, remove the paper guide installed in
groove b in illustration D, and install it in groove a.
Remove the paper guide installed in grooves b by following the same steps as
1.
"Setting the Paper Width to 82.5 mm."
2. Install the removed paper guide in groove a in illustration D so that the
projection of the paper guide is aligned with the hole along the groove.
3. Fix the paper guide with the screw.

Connecting the Cables

CAUTION:
For a serial interface, use a null modem cable.
For a USB interface, do not turn on the printer before installing the printer driver.
Note:
Available interfaces vary by the printer model. For the positions and shapes of the
connectors on the back of the printer, see illustration F.
1. Make sure the power switch is off.
2. Connect the power cable to the power supply connector.
3. Connect each interface cable to the printer. When using the USB interface,
install the cable hook and fix the USB cable to prevent it from coming off. (See
illustration G)
4. Connect the interface cable to the computer.
5. Insert the power cable plug into a socket.

Loading Paper

When the Paper LED is on, follow the steps below to load paper.
Caution:
Be sure to use the specified paper.
Set the paper width properly for the paper you want to use. For how to set the
paper width, see "Setting the Paper Width" on page 9.
1. Turn on the printer.
2. Open the paper loading cover by pulling up the cover open lever. (See
illustration C)
3. Insert the end of the paper under the rollers. (See illustration H)
4. Close the paper loading cover.
10 TM-L500A Ticket User's Manual