Using The Harness; Adjusting The Legrest; Folding The Stroller; Attaching An Infant Car Seat - Evenflo Gold OTTO Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE HARNESS

WARNING
Avoid serious injury from falling or sliding out.
Always use waist restraint.
To attach harness, click buckles into crotch strap buckle.
Pull waist straps to tighten. Shoulder straps must be at
shoulder height or lower, closest to the baby's shoulders.
CLICK!

ADJUSTING THE LEGREST

CLICK!
To adjust legrest, squeeze buttons inside the seat pad on
either side of stroller as shown. Rotate up or down until it
clicks into place.
8
DEATH or SERIOUS
INJURY can occur.
To adjust height of strap, first remove harness covers.
Undo hook-and-loop strips then release elastic from
around back of buckle.
For a snug, comfortable fit, adjust height of strap and
tighten, pull down on the free end of strap.
To loosen straps, push up on retainer and pull shoulder
strap down.
Replace harness covers by feeding it under the strap
and lining up bottom of notch under buckle (black side
facing you).
Find elastic and place around buckle. Connect hook-
and-loop strips to close harness cover.
To unlock harness, push the button on crotch buckle.
To adjust center strap, pull straps to tighten.
To loosen, adjust center strap buckle as shown.
WARNING
Care must be taken when folding or unfolding stroller to prevent finger injury to you or your child in hinge areas.
To fold the stroller, lock the rear brakes, close the canopy, and remove your child.
Press the Safety Button and squeeze the Fold Release on the Parent's Handle.
After pressing the Fold Release, gently lift the Parent's Handle forward and release. Stroller will continue to fold
on its own.
Safety
Button
Fold
Release
WARNING
Make sure the infant car seat is securely attached into the seat mounts on both sides of the stroller before
placing child in the seat.
Only use Evenflo SecureMax™, SafeMax™, LiteMax™, LiteMax DLX™, and LiteMax™ Sport infant car
seats with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and if used
with this stroller, may result in serious injury to your child.
To ensure safety for your baby, please refer to the manufacturer's instructions for the use of your
recommended infant car seats and keep all instructions available for reference.
DO NOT lift stroller by using the infant car seat handle when installed on stroller.
DO NOT use infant car seat without bumper bar attached.
If unable to securely attach your infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink
at 1-800-233-2229 (USA or Canada).

FOLDING THE STROLLER

DEATH or SERIOUS
INJURY can occur.
NOTE: To unfold the stroller, see page 4.
CLICK!

ATTACHING AN INFANT CAR SEAT

DEATH or SERIOUS
INJURY can occur.
To attach infant car seat to stroller seat, fully recline
stroller by squeezing adjuster on the recline strap and
lowering the backrest.
Insert infant car seat into stroller parent-facing until it
latches into the infant car seat attachment points as
shown.
The infant car seat MUST be facing the parent when
installed.
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido