Using Your Stroller With The Litemax™ Or Safemax™ Infant Car Seat - Evenflo Folio3 Stroll & Jog Manual Del Usuario

USING YOUR STROLLER WITH THE LITEMAX
• Only use Evenflo LiteMax™ and SafeMax™ infant car seats with this stroller.
Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your
child if used with this stroller .
• To assure safety for your baby, please refer to the manufacturer's instructions for the use of your infant car seat and
keep all instructions available for reference .
• DO NOT lift stroller by using the infant car seat handle when installed on stroller .
• DO NOT use stroller for jogging while infant car seat is in stroller .
• If unable to securely attach infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink at
1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
• To avoid serious injury to the child, when the infant car seat is in the stroller, make sure the infant car seat is securely
snapped into the car seat mounts .
• Some Evenflo LiteMax™ and SafeMax™ infant car seats have a blanket/boot option that must be removed for
proper attachment to this stroller .
1. Fully recline the stroller seat back (page 6).
2. Make sure the child tray is securely latched (page 4).
3. The infant car seat
A
Position infant car seat over the stroller. Touch rear vertical surface
child tray. Lower the infant car seat into the stroller and push down on handle. Infant car seat will click when fully locked
into place.
4. Pull up on the front and back of the infant car seat to ensure that it is properly locked into place.
B
C
D
CHECKLIST FOR PROPER INSTALLATION
• Make sure the infant car seat
parent).
• Make sure the infant car seat is securely locked into the car seat mounts
and resting on the child tray
Note: Car seat mounts are behind fabric, and not visible .
• Pull up on the front and back of the infant car seat to test that it is properly
locked into place.
8
™
or SAFEMAX
MUST be facing the parent when installed.
A
CLICK!
is in the rear-facing position (facing the
A
.
C
™
INFANT CAR SEAT
WARNING
of infant car seat against rear vertical surface
B
C
D
D
of
C