Hisense WFHV6012EM Manual Del Usuario página 20

For Models with Dual Inlets
If you wish to connect hot and cold water supply (Fig.1):
1. Fix the red marked inlet hose to the hot water tap and to the inlet valve
with
2. Fix the other inlet hose to the cold water tap and to the inlet valve with the
Make sure:
a） The connec
b）
vice versa)
If you wish to connect only the cold fill follow the below instructions (Fig. 2):
1. You need a Y-piece connec tor. This can be purchased from local
hardware or plumbing supplier.
2. Fix the Y-piece connec
3. Connect the two inlet valves present on the rear part of the machine to
the Y-piece connector using the hoses provided.
For Models with Single Inlet
Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the
machine as Fig. 3
Ensure that:
All connections are tightly fixed
Do not allow children to operate, crawl on, be near or inside your washer.
Note that during the wash cycles, the surface temperature of the porthole
door may increase.
Close supervision of children is necessary when the appliance is
used near children.
Hot
fill
Red inlet
valve
Blue inlet
valve
Fig.1
Cold
fill
Red inlet
valve
Blue inlet
valve
Cold
Y- fill
piece
Fig.2
16
inlet valve and .
Cold
ll
Inlet
valve
Fig.3