Fault Code - Hisense WFHV6012EM Manual Del Usuario

C. Fault code
The washer stops when the program is running. The display window
shows fault code "F02/F24", fault codes from "F04' to "F07", "F13","F14","F23" or "Unb".
If fault code "F02/F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply and
contact with after-sale service.
If fault code "F04" to "F07", "F23" shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect power
supply and contact with after-sale service.
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door (PTC) to
check whether the door is closed.
Open and close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect power
supply and contact with after-sale service.
If fault code "F1 " is shown
Door open fault..
Action: Press "Start/Pause" button. The washing machine will try to open the door. The
alarm will not be removed until the door is unlocked. Or, turn the nub to Off for 3
seconds to turn off the machine. Choose the desired programmme to start the machine.
The alarm will be removed.
nb
Unbalance alarm shall be solved by the following methods
1.Laundry winding.
Turn the knob to "off" for 3 seconds for shutdown, open the door, shake the clothes
and put them back into the washing machine, then select the single dewatering
program to dry again
.2.Too light-weighted laundry
Turn the knob to "off" for 3 seconds for shutdown, open the door, put in one or two
towels, and then select the single dewatering program to dry again.
If fault occurs again, disconnect power supply and contact with after-sale service.
18