Display Messages And Error Codes - CTX Mighty Chef TCO21140063 Manual De Instalacion Y Operacion Del Propietario

I. DISPLAY MESSAGES AND ERROR CODES
DISPLAY SHOWS PROBLEM
Flashing tem- Set Temperatures or Cook
peratures or Time Outside of Allowed
cook times dur- Range
ing program-
ming, and oven
is beeping
OFF
Heating Element turned off
- - - -
No Menu Selection Chosen
E-00
Preset Menu Program Lost
E-01
High Ambient Condition
Temperature inside the con-
trol enclosure exceeds 65°C.
The oven shuts down, then
beeps continuously.
E-02
Conveyor Runaway
The conveyor runs at full
speed. The oven shuts down,
then beeps continuously.
E-04
Conveyor Loose or Jammed
Conveyor is stopped when
the speed setting is between
0:15 and 15:00.
E-35
Top Heating Zone Failure
E-36
Bottom Heating Zone Failure
Heating Zone Temperature
E-40
High Limit
One or both of the heating
zones have reached a tem-
perature greater than 315°C.
All manuals and user guides at all-guides.com
ACTION
Re-enter the program using Set Temperatures and Cook Time
within the allowed range. Also, refer to Part E, Programming
Preset Menu Selections, in this Section.
If the element should be on, re-enter the program using Set
Temperatures within the allowed range. Also, refer to Part E,
Programming Preset Menu Selections, in this Section.
Choose or program a preset menu selection.
Re-enter the Preset Menu program.
Check the cooling fan (centered on the front panel of the oven) for
cleanliness and proper operation. If the fan is not running after the
oven heats, or the oven remains in a high ambient condition,
contact your local Authorized Service Agent.
Check for the proper speed setting by pressing
setting is correct, and the conveyor continues to run at full speed,
contact your Authorized Service Agent.
Switch the Power On/Off (I/O) Switch to the OFF (“O”) position.
Switch the breaker/fused disconnect to the OFF position. Allow
the oven to cool for at least 30 minutes.
CAUTION - HOT
DO NOT ATTEMPT TO FREE A JAMMED CONVEYOR
BELT WHILE THE COOKING CHAMBER IS WARM.
SEVERE INJURY MAY RESULT.
If the conveyor is jammed, free the obstruction from the conveyor
belt. If the conveyor still will not operate properly after the jam is
cleared, OR if the error message appears when the conveyor is
NOT jammed, contact your local authorized service agent.
Contact your local authorized service agent.
Contact your local authorized service agent.
Contact your local authorized service agent.
10
. If the speed