Set Al1 Or/And Al2 On Or Off; Snooze.function - LEXIBOOK RLR800 Manual De Instrucciones

Adjusting the time for AL2
1. In normal clock display mode, press the SET.button TWICE.to.
display.the.set.time.for.ALARM...The.display.shows.AL2.on.the.
right.
2. Once the display shows the set time for AL2, press the SET.button.
for..seconds.to.enter.in.the.alarm.time.setting.mode..A.bell.symbol.
appears.on.the.display.between.the.hour.and.the.minutes.
..You.can.adjust.the.hour.and.minutes.by.pressing.the.UP.or.DOWN.
buttons.and.then.pressing.SET each time to confirm.
4..The.display.then.goes.back.to.normal.clock.display.mode.and.the.bell.
symbol.remains.on.the.display.to.signal.that.AL.is.on.
Note: During the setting process, if there is no confirmation within 30
seconds, the display will automatically go back to normal clock display
mode.

Set AL1 or/and AL2 on or off

In normal clock display mode, press the ALM.button.to.switch.the.
alarms.on.or.off.
The sequence is:
AL1 on Ë AL1 off and AL2 on Ë AL1 and AL2 on Ë AL1 and AL2 off.
Note:.the.alarm.rings.for..minutes.with.4.levels.of.increasing.volume.
Snooze function
1. When the alarm is ringing, the bell symbol flashes on the display.
Press.the.LIGHT/SNOOZE.button.to.temporarily.turn.off.the.alarm.
and.use.the.snooze.function..
2. When the snooze function is on, the bell symbol stays constant on
the display and the snooze symbol flashes.
3. The alarm will be repeated every 5 minutes and the LED lights will
stay.on.for.5.seconds.
All manuals and user guides at all-guides.com
17