Power Supply; Listening To The Radio; Playing Cds - Clatronic SR 777 CD Instrucciones De Servicio

Cd-player-radio-estereo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used for
commercial purposes.
Any other use of this device is considered to be contrary to the
intended use and may result in damage to materials or even
personal injury.
The fi rm Clatronic International GmbH does not accept any
liability for damage caused as a result of the use of this device
contrary to its intended use.
Start-up of the device/introduction
Please read the operating instructions carefully before using
the device for the fi rst time!
Select a suitable location for the device, such as a dry, fl at,
non-slip surface on which it is easy to operate the machine.
Ensure that the device is suffi ciently ventilated!
Remove the protective fi lm from the display if it is still
present.

Power Supply

Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed 230 V / 50 Hz
safety power socket and the mains connector AC ~ (17) on
the back of the machine.
Ensure that the voltage is the same as that indicated on the
model identifi cation plate.
Setting the Time (in Standby Mode)
1. Open the battery compartment (19) on the bottom.
2. Keep the SET button pressed down. Press the HOUR
button at the same time in order to set the hours.
3. In order to set the minutes, keep the SET button pressed
down and press the MINUTE button at the same time.
4. Close the battery compartment.
NOTE:
The time is a 12 hour display.
AM = in the morning; PM = in the afternoon/evening.
Inserting the Batteries (not supplied)
Open the battery compartment (19) on the bottom.
Insert 6 batteries of type UM2/R14 1,5V. Please ensure that
the polarity is correct (see the inside of the battery compart-
ment)!
If the device is not used for a long period of time, remove the
batteries to avoid the spilling of battery acid.
Close the battery compartment.
NOTE:
When a mains cable is connected the batteries are automati-
cally switched off.
26
05-SR 777 CD.indd 26
05-SR 777 CD.indd 26
All manuals and user guides at all-guides.com
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
Transport Safety Device, CD Compartment
Switch-off
The machine is switched off when the function selector switch
(16) is turned to the OFF position. Unplug the device.
Volume
The desired volume can be sent using the VOLUME regulator
(15).
1. Turn the function selector switch (16) to the RADIO position.
2. Select the desired frequency band with the band selection
3. Tune into the desired station using the TUNING regulator
4. The FM.ST control lamp only lights up when you have se-
5. For VHF/FM mode pull out the telescopic antenna (1) and
6. An aerial is integrated into the device for the reception of
1. Push the function selection switch (16) to CD.
2. Open the CD compartment (3) by pulling the lid upwards by
3. Insert an audio CD with the printed side facing upwards on
CAUTION:
Different battery types or new and used batteries must not
be used together.
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.
WARNING:
Open the CD compartment (3) by pulling the lid upwards by
the tab (4).
Before operating the machine for the fi rst time, remove
the transport safety device from the CD player if it is still in
place.

Listening to the Radio

switch (20).
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
(21).
lected FM stereo and the station is being received in stereo
quality. If reception is too weak and there is noise on the
station being received, this lamp will fl icker. Where reception
is bad we recommend switching to FM.
turn it to improve reception.
AM stations. The machine can be aligned to the station by
turning it. In this frequency band programs are transmitted in
„mono" only.
Playing CD's
the tab (4).
to the central cone so that the CD clicks into place and then
close the lid of the CD compartment.
17.12.2007 12:32:38 Uhr
17.12.2007 12:32:38 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido