Stadler Form Anna Manual De Instrucciones página 6

ner. do not use on soft surfaces, like a bed, where openings may become
blocked.
• a fan heater has hot or arcing or sparking parts inside. do not use it in
areas where gasoline, paint, or flammable liquids are used or stored.
• Use this heater only as described in this manual. any other use not rec-
ommended by the manufacturer may cause fire, electric shock, or injury
to persons.
• to prevent overload and blown fuses, be sure that no other appliance is
plugged into the same outlet (receptacle) or into another outlet (recep-
tacle) wired into the same circuit.
• it is normal for the heater's plug and cord to feel warm to the touch. a plug
or cord which becomes hot to the touch or becomes distorted in shape
may be a result of a worn electrical outlet (receptacle). worn outlets or
receptacles should be replaced prior to further use of the heater. Plugging
heater into a worn outlet/receptacle/ may result in overheating of the
power cord or fire.
• this heater is not intended for use with an extension cord. Plug the cord
directly into an appropriate wall receptable.
• Be sure that the plug is fully inserted into an appropriate receptacle. Please
remember that receptacles also deteriorate due to aging and continuous
use: check periodically if signs overheating or deformations are evidenced
by the plug. do not use the receptacle and CaLL your electrician.
• Check that neither the appliance nor the power cable have been damaged
in any way during transportation.
• CaUtiOn: to prevent electric shock match wide blade of plug to wide
slot, fully insert.
• do not cover the appliance while it is functioning in order to avoid over-
heating with the attendant risk of fire.
• do not use this heater in the immediate proximity of showers, bathrubs,
swimming pools, etc.
• always use the heater in an upright position.
• do not use the heater to dry your laundry. never obstruct the intake and
outtake grilles (danger of overheating).
• do not use the appliance close to walls, furniture, curtains etc.
• if the power cable is damaged, it must be replaced by the manufacturer,
an authorized service center or a qualified electrician in order to eliminate
all risk.
• do not cover the appliance when in operation as this could cause a fire
risk.
• do not use the appliance in rooms less than 4 m
• the heater is fitted with a safety thermal cut-off which will switch off the
SAVE THESE INSTRUCTIONS
Setup / operation
1. having set up the anna heater in the desired position connect the cable
(9) to the household supply socket.
2. Switch on anna by clicking the on/off button (2)
3. Using the output button (3), you can control the heating output of anna
a. Switch in = 1500w / 800w (little)
b. Switch out = 1200 w / 700w (little)
4. room thermostat (4): the room thermostat control allows an infinitely
(43 square feet).
2