Publicidad
A. Package Contents
Dispenser
Push button lock insert
Mounting bracket
Key lock insert
(2) Adhesive tape
Key
Alcohol pad
(4) D size alkaline batteries
KEY
B. Dispenser Lock Installation
1. Choose lock option.
2. Insert lock into opening in top
of cover.
KEY LOCK
OPTION
C. Installation Instructions
Install dispenser using mounting bracket provided.
Note: Mounting should comply with ADA Guidelines.
Compliance is the responsibility of the installer.
DISPENSER - BACK VIEW
BRACKET - BACK VIEW
SCREW
MOUNTING
HOLES
TAPE
DISPENSER
RELEASE
TAB
8-10"
6-8"
COUNTERTOP
44" MAXIMUM FROM FLOOR
Installation with bracket and screws
1. Position bracket and mark holes using bracket as a template.
2. Drill holes and attach bracket using appropriate anchors and screws.
3. Align dispenser on bracket and gently push downward until it clicks.
4. To remove, press dispenser release tab while lifting the dispenser
upward.
.
Installation with bracket and tape
1. Clean bracket and mounting surface with alcohol pad.
2. Attach tape to bracket and position bracket on wall.
3. Press bracket firmly to wall for 30 seconds.
Caution - Wait 24 hours before attaching the dispenser.
All manuals and user guides at all-guides.com
enMotion
Automated Touchless Soap Dispenser Operating and Installation Instructions
™
D. Portion Control Adjustment
PUSH BUTTON
E. Battery Loading
LOCK OPTION
1. Press finger tab and open battery covers.
2. Install batteries as shown.
(Use only D size alkaline batteries)
3. Close battery covers. Right LED flashes on power-up.
1
TAPE
F. LED Light Function
1. Operation Light: Illuminates when
dispensing.
2. Low Battery Light: Flashes at power-up
and is on solid when batteries require
replacement.
G. Maintenance Mode
0.4 mL
0.7 mL
PORTION
PORTION
H. Refill Instructions
INSTALL
2
B a t t e
r y
B a t t e
B a t t e
r y
B a t t e
REMOVE
3
2
1
2
enMotion is a trademark of Georgia-Pacific Consumer Products LP.
© 2009 Georgia-Pacific Consumer Products LP. All rights reserved.
Dispenser can be set in maintenance
mode for cleaning.
1. To set, press and hold the button located
on side of dispenser. Hold until LED on left
flashes indicating the dispenser is
temporarily disabled. After 20 seconds the
dispenser will automatically return to
dispense mode.
2
1
Use only with enMotion
1
Contact Georgia-Pacific at:
1
ENGLISH
1
3
™
product refills.
Need Assistance?
1-866-HELLO GP
(1-866-435-5647)
www.gppro.com
GP5076.0902
Publicidad
