Honeywell HCM-890 Serie Manual Del Propietário página 4

SET UP
NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall
for proper air flow (Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage
furniture and some flooring. Kaz will not accept responsibility for property
damage caused by water spillage.
FILLING
Fig. 1
• Remove the water tank by grasping the handle and pulling straight up
(Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2). Remove the
Natural Cool Moisture filter from the base before filling the unit with water.
Soak in a sink full of cool water to help reduce mineral build up and place
back in the humidifier while wet. DO NOT SQUEEZE OR WRING OUT THE
NATURAL COOL MOISTURE FILTER. To help extend the life of your filter
repeat this step each time you fill your humidifier.
• Turn the water tank upside down so that the fill cap is facing up; unscrew the
fill cap by turning it counter-clockwise
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is not
necessary as the water is filtered by the Natural Cool Moisture filter.
DO NOT USE HOT WATER. Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise
Turn the water tank right-side up.
All manuals and user guides at all-guides.com
Fig. 2
Lift
6"
Fig. 3
and set aside.
. DO NOT OVER TIGHTEN.