Technical Data - Hansgrohe AXOR Urquiola 11420000 Instrucciones De Montaje

Important! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
The hot and cold supplies must be of equal pressures.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G ½": cold right - hot left
Rate of flow:
anti-pollution function
To adjust the hot water limiter on single lever mixers, please
see page 37.
No adjustment is necessary when using a continuous flow
water heater.
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
Fault
Insufficient water
Mixer stiff
Mixer dripping
Instantaneous heater didn't work
Hot water temperature too low

English
Important!
The non return valves must be checked once a year.
Spare parts (see page 3)
1
2
3
4
5
6
7
max. 1 MPa 8
0,1 - 0,5 MPa 9
1,6 MPa 10
11
max. 80° C 12
65° C 13
150 ± 16 mm
14
15
17 l/min 0,3 MPa
Cause
-Shower filter seal dirty
-Non return valve hasn't moved back
-Cartridge defective, calcified
-Cartridge defective
-Hot water limiter incorrectly set
-Flow limiter in handshower isn't
removed
-Filters are dirty
-Non return valve hasn't moved back
handle
flange
nut
cartridge cpl.
sleeve
S-union
aerator cpl.
selector assy
non return valve.
noise reduction
connecting thread
locking screw for handle
seal
seal
connecting thread
Remedy
-Clean filter seal between shower
and hose
-Exchange non return valves
-Exchange cartridge
-Exchange cartridge
-Set hot water limiter
-Remove flow limiter
-Clean the filter / exchange filter
-Exchange non return valves
11094000
96763000
97209000
92730000
97738000
94136000
13956000
94077000
94074000
94073000
97236000
96059000
95008000
97530000
95367000