Troubleshooting - Sunny SF-RB4905 Manual Del Usuario

7. CALORIES:
Accumulates calories burned during training from 0.0 to 9999 Cal. The user may also preset the
target calories before training by pressing the SET & MODE buttons. Each setting increment is 1 cal.
Automatically counts down from targeting value during exercise.
NOTE: This data is a rough guide which cannot be used in medical treatment.
8. ODOMETER:
Displays the total accumulated distance from 0 to 9999 M (Miles). User can also press MODE
button to display the odometer value.
9. PULSE:
The computer will display the user's heart rate in beats per minute during training.
NOTE: This data is a rough guide which cannot be used in medical treatment.
10. RESET:
Press the button and hold for 3 seconds to reset all values except odometer to zero.
NOTE:
1. If the computer displays abnormally, please re-install the new batteries and try again. Always
change both batteries at the same time. Do not mix battery types and do not mix old and new
batteries.
2. Battery Spec: 1.5V UM-4 or AAA (2PCS).
3. Dispose the batteries safely, according to your state and regional guidelines.
PROBLEM
There is no display on the computer.
The recumbent bike wobbles when in use.
The recumbent bike makes squeaking noise
when in use.

TROUBLESHOOTING

1. Remove the computer and verify that the wire
2. Check if the batteries are correctly positioned
3. The batteries in the computer may be
Turn the rear end caps on the rear stabilizer as
needed to level the recumbent bike.
The bolts may have become loose on the
recumbent bike. Please inspect all the bolts and
tighten any loosened bolts.
18
SOLUTION
from the computer is properly connected to the
wire that comes from the front post.
and battery springs are in proper contact with
batteries.
unresponsive. Change to new batteries.
Version 1.5